Saturday, March 9, 2019

networking - Trouble with WPA wifi connection - can connect to wireless networks

Good afternoon,


I'm trying to set up wireless on a new install of Ubuntu Desktop 12.10.


I am able to connect to "open" wireless networks (I am connected to my house "guest" wifi network right now) - therefore the problem is not with the wireless card or firmware (I've done b43-fwcutter & firmware installs).


The issue is just when trying to connect to my WPA2 secure "normal" wifi network ("bkhouse"). It just won't seem to go... It appears that I can connect to the SSID, but it won't complete the connection.


Help would be appreciated!!


brandon@linux-desktop:/etc/wpa_supplicant$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:25:64:db:89:16
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:1517 errors:0 dropped:0 overruns:0 frame:0
TX packets:944 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1802381 (1.8 MB) TX bytes:95348 (95.3 KB)
Interrupt:17
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:8926 errors:0 dropped:0 overruns:0 frame:0
TX packets:8926 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:737296 (737.2 KB) TX bytes:737296 (737.2 KB)
wlan0 Link encap:Ethernet HWaddr 00:0f:66:6f:19:2c
inet6 addr: fd63:da35:957a:0:20f:66ff:fe6f:192c/64 Scope:Global
inet6 addr: fe80::20f:66ff:fe6f:192c/64 Scope:Link
inet6 addr: fd63:da35:957a:0:cc16:dc3c:c7f5:e400/64 Scope:Global
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4397 errors:0 dropped:0 overruns:0 frame:0
TX packets:3964 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2716198 (2.7 MB) TX bytes:827754 (827.7 KB)
brandon@linux-desktop:/etc/wpa_supplicant$ iwconfig
eth0 no wireless extensions.
lo no wireless extensions.
wlan0 IEEE 802.11bg ESSID:"bkhouse"
Mode:Managed Frequency:2.462 GHz Access Point: 58:6D:8F:28:26:69
Bit Rate=48 Mb/s Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=63/70 Signal level=-47 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:40 Missed beacon:0

P.S. I've tried all kinds of different configurations with wpa_supplicant but haven't been able to sort anything out!

No comments:

Post a Comment

11.10 - Can't boot from USB after installing Ubuntu

I bought a Samsung series 5 notebook and a very strange thing happened: I installed Ubuntu 11.10 from a usb pen drive but when I restarted (...