Thursday, August 24, 2017

networking - Ubuntu 16.04 Network Issues


I have been having issues with networking for a very long time. The worst is when I am at home but there are also issues at school sometimes. I'll start from the beginning.


I first started having issues when I moved in with my family. I had Windows 10 and the wifi would sometimes disconnect. I installed ubuntu 16.04 on that laptop and still had issues connecting and with random network drops. At this point, `sudo service network-manager restart' usually works for a short time, but then it starts acting up again an hour or two later. I assumed at this point the issue was with my wireless card and I went out and bought a new laptop.


EDIT: also note that at this point I had no issues when I was on campus or if I used the mobile hotspot on my phone or tablet. It was only the home router that refused to stay connected).


I am now on a dell laptop that is specifically listed as being compatible with Ubuntu (a Dell Latitude E6420). I immediately installed Ubuntu 16.04. At this point the only issue with networking was the occasional network drop and reconnect, usually after coming back from suspend.


I upgraded to Ubuntu Gnome 16.10 and the issues got worse. Now I am back to Ubuntu Gnome 16.04 and nothing is getting better.


I have tried using wicd but wicd doesn't even connect to the network unless network-manager is running, and even then it doesn't make a difference. This seems to be the only solution anybody can come up with. I don't know what commands to use to get more information so let me know and I will tell you what you need.


$ ifconfig
eno1 Link encap:Ethernet HWaddr e0:db:55:dd:5a:82
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:20 Memory:e6e00000-e6e20000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:9454 errors:0 dropped:0 overruns:0 frame:0
TX packets:9454 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1
RX bytes:709546 (709.5 KB) TX bytes:709546 (709.5 KB)
wlp3s0 Link encap:Ethernet HWaddr 84:3a:4b:56:4a:9e
inet addr:192.168.0.17 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::5f18:be7:8291:2b8f/64 Scope:Link
inet6 addr: 2607:fcc8:6a41:3900:36b3:fd71:a6b3:97bf/64 Scope:Global
inet6 addr: 2607:fcc8:6a41:3900:4545:66d0:48b:b8e2/64 Scope:Global
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:25275 errors:0 dropped:0 overruns:0 frame:0
TX packets:17066 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:27895660 (27.8 MB) TX bytes:2478205 (2.4 MB)
$ sudo lshw -C network
[sudo] password for guinevere:
*-network
description: Ethernet interface
product: 82579LM Gigabit Network Connection
vendor: Intel Corporation
physical id: 19
bus info: pci@0000:00:19.0
logical name: eno1
version: 04
serial: e0:db:55:dd:5a:82
capacity: 1Gbit/s
width: 32 bits
clock: 33MHz
capabilities: pm msi bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=e1000e driverversion=3.2.6-k firmware=0.13-3 latency=0 link=no multicast=yes port=twisted pair
resources: irq:30 memory:e6e00000-e6e1ffff memory:e6e80000-e6e80fff ioport:5080(size=32)
*-network
description: Wireless interface
product: Centrino Advanced-N 6205 [Taylor Peak]
vendor: Intel Corporation
physical id: 0
bus info: pci@0000:03:00.0
logical name: wlp3s0
version: 34
serial: 84:3a:4b:56:4a:9e
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=iwlwifi driverversion=4.8.0-36-generic firmware=18.168.6.1 ip=192.168.0.17 latency=0 link=yes multicast=yes wireless=IEEE 802.11
resources: irq:29 memory:e6d00000-e6d01fff


It might be worth disabling the n option of the IEEE802.11 and the power management.


The instructions on how to achieve this can be found in the link below under the Force Disable 802.11n heading.


https://www.linux.com/learn/tips-and-tricks-get-most-out-your-linux-wifi


No comments:

Post a Comment

11.10 - Can't boot from USB after installing Ubuntu

I bought a Samsung series 5 notebook and a very strange thing happened: I installed Ubuntu 11.10 from a usb pen drive but when I restarted (...