broadcom - Wireless doesn't work after installing 11.10

Possible Duplicate:
Broadcom BCM4311 Wireless not working

I just did a fresh install of 11.10 32 bit and I can't get my wireless to work. I installed the drivers the Broadcom STA wireless drivers through additional drivers and rebooted, but it still doesn't see any wireless networks

Did something change in 11.10 that makes the wireless card not work anymore? I was using 10.10 before, and it worked fine.

Do I need to go back to 10.10?

sudo lshw -C network
[sudo] password for user1: 

  *-network               
       description: Ethernet interface
       product: NetLink BCM5784M Gigabit Ethernet PCIe
       vendor: Broadcom Corporation
       physical id: 0
       bus info: pci@0000:03:00.0
       logical name: eth0
       version: 10
       serial: 00:1f:16:be:55:ff
       size: 100Mbit/s

       capacity: 1Gbit/s
       width: 64 bits
       clock: 33MHz
       capabilities: pm vpd msi pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=tg3 driverversion=3.119 duplex=full firmware=sb v2.19 ip=192.168.0.70 latency=0 link=yes multicast=yes port=twisted pair speed=100Mbit/s
       resources: irq:43 memory:f0300000-f030ffff
  *-network UNCLAIMED
       description: Network controller
       product: BCM4311 802.11b/g WLAN
       vendor: Broadcom Corporation

       physical id: 0
       bus info: pci@0000:09:00.0
       version: 01
       width: 32 bits
       clock: 33MHz
       capabilities: pm msi pciexpress bus_master cap_list
       configuration: latency=0
       resources: memory:f0400000-f0403fff